AUTONET TV

Keeping Yourself in Suspension (Control Arm Assembly Replacement)

When you are pointing your vehicle straight down the street, it should go straight.  That’s pretty straightforward, right? Sometimes, though, you may notice you have to keep adjusting the steering wheel to keep going straight.  While that could be caused by many different issues, one possibility is that you have a failing or bent control arm.

Another sign is that when you brake, your vehicle pulls to one side or the other.  Sometimes your suspension may sound noisy, especially when you’re traveling on rough surfaces.  A damaged control arm may also make it almost impossible for you to get a good wheel alignment. 

The control arms are part of your suspension, and some vehicles have upper control arms and lower control arms.  Not all have the same number of control arms, but one thing is important: If you have worn bushings on your control arms or a worn-out ball joint, the control arm on the other side should also be replaced.  The rubber bushings are susceptible to damage from age and exposure to the elements, and ball joints usually shouldn’t be replaced separately. 

Any time you have a suspension issue, it’s important that a technician inspects the other parts of your suspension as well.  If one part of it is showing its age, it’s not unusual for other components to show similar wear.  

One other thing.  If you’ve had one of your control arms bent or damaged in an accident, you must have it replaced.  Your suspension is an important part of your vehicle’s safety and handling, so you should keep it in good operating condition.  After all, your life is riding on it, literally.   

Car Doc On The Island
419 South Tamiami Trail
Venice, FL 34285
(941) 786-1595
http://www.cardocontheisland.com

The Last Gas (Fuel Pump Replacement).

You're heading down the road and you notice your vehicle is sputtering, like it's running out of gas.  But the gauge show's it's still got a quarter of a tank.  So what gives?

It could be that your fuel pump is failing, meaning your engine is not getting enough gas to run properly.  While fuel pumps are built to last a long time, sometimes they fail.  Other symptoms you may have a bad fuel pump include your vehicle stalling and then refusing to start again, the engine overheating or a hum or whirr coming from around the gas tank.  Or, your Check Engine light may come on.

Most fuel pumps are in the gas tank. They have a small electric motor in them.   When you bring your vehicle to our service center, a technician will run tests to confirm the fuel pump is getting power to it but has failed.  Some vehicles have an access panel so the fuel pump can be removed and replaced. 

But in some vehicles that don't have that access panel, the technician has to drain the fuel and take the tank out of the vehicle to be able to replace the fuel pump inside.  Some parts such as brackets that attach the pump can be reused when the new fuel pump is installed.  Most technicians will recommend replacing the fuel filter at the same time the fuel pump is changed out.

If the technician has to remove the fuel tank, they'll also check for rust and corrosion and replace any affected parts.

Keep one thing in mind - your vehicle's fuel pump is in the fuel tank because it's kept cool and lubricated by the gasoline in the tank.  Try not to let your fuel level go below a half or quarter of a tank to maximize the life of your fuel pump.  Also, try to use Top Tier gasoline that has higher standards than some other fuels.  Your engine—and fuel pump—will thank you.

Car Doc On The Island
419 South Tamiami Trail
Venice, FL 34285
(941) 786-1595
http://www.cardocontheisland.com

A Clean Start (Battery Cleaning)

Your vehicle is loaded with electrical devices. Computerized components are everywhere, so good electrical connections are important.  Those begin with your vehicle's battery, so it's important that its connections are in top shape.

Ever had a flashlight that didn't work, took out the old batteries to replace them and noticed the old batteries were all corroded? The same thing can happen to your vehicle's battery. 

The battery type used in most vehicles is a lead-acid, which can be very corrosive.  Corrosion can build up around your battery's terminals that can prevent the electrical connection from being as solid as it needs to be.  You may have even seen discoloration around your battery's terminals if you look under the hood, a sign of corrosion.

Or you might notice visible signs of fraying or loose battery cables. All of your vehicle's components are affected by vibrations from the engine and road surface imperfections, and the battery cables take a lot of jostling every time you drive.  Frayed cables won't conduct as much electricity as intact ones.  Plus, there's the possibility that a frayed cable may touch a piece of metal in the engine compartment that can cause shorts and other problems.

There are some signs to watch out for that might tell you if your battery terminals are corroded or your cables aren't making good contact with them.  You might find your vehicle isn't starting as easily as it used to. You also might see the battery warning light illuminated on your dash. That light looks like a rectangle with a "-" and "+" sign inside.

Our technicians can make sure your battery and cables are at optimal operating capability with regular service and cleaning.  A technician will clean the terminals and portions of the cables that are connected to them.  They may also add an anti-corrosion agent to the cables/terminals. Nothing like giving your vehicle a clean start!

Car Doc On The Island
419 South Tamiami Trail
Venice, FL 34285
(941) 786-1595
http://www.cardocontheisland.com

What is a TPS? (Throttle Position Sensor)

You know you have an accelerator pedal; step on it and your vehicle is supposed to go.  But did you know there is a part in your vehicle that keeps track of where the throttle is? It's called the Throttle Position Sensor, or TPS.

The TPS is a sensor that helps your vehicle figure out the right mix of air and fuel is reaching your engine.  It does that by keeping track of the throttle and sending that information to your vehicle's computer.  Other factors play a role in how well your engine is performing, including air temperature, how fast the engine is turning over and air flow. 

When the TPS isn't working right, you may find your vehicle won't accelerate or doesn't have the power you're expecting when you press on the accelerator.  In some cases, it may accelerate on its own.  Sometimes your vehicle won't go over a certain speed.  Your Check Engine light may go on.

Any of these symptoms should be checked out soon.  If your TPS stops working right, your vehicle may not be safe to drive.  Fortunately, most vehicles have a "limp home" mode that will allow you to get off a busy road to a safe spot. 

Your service advisor can let you know which TPS is the correct replacement for your vehicle.  Your shop may have to re-program the new TPS so it works correctly with other software in your vehicle.

It's a fact of life these days that computers control many of a vehicle's functions. The sensors that feed information to those computers help make your vehicle work the way it was engineered to and keep you motoring down the road safely and efficiently.

Car Doc On The Island
419 South Tamiami Trail
Venice, FL 34285
(941) 786-1595
http://www.cardocontheisland.com

The Sign of the Shield (Heat Shield Repair and Replacement)

Even in the months where temperatures are cooler, heat is still an enemy of your vehicle.  When your engine runs, it creates heat, so there are numerous heat shields that protect other parts from those higher temperatures. Heat shields are installed around several areas of the exhaust system.  Others prevent heat from reaching parts of the vehicle.  Still others prevent heat from reaching the ground (or maybe grass underneath) and starting a fire. 

If you remember your space travel history, you'll know how important a heat shield can be. John Glenn was the first American to orbit the earth, but during that maiden orbital flight, a sensor on board was indicating the heat shield on his capsule, Friendship 7, was loose.  If it had come off, his spacecraft could have burned up upon re-entry.  Fortunately, the heat shield stayed on, and Glenn made history.

Unfortunately, the heat shields on your vehicle don't have warning systems like the space vehicles did.  So you have to maintain them.  Heat shields are constantly exposed to elements like water, salt, sand and dirt.  That makes them prone to rusting and corroding.  Here's one unfortunate fact: Materials that make them good at preventing heat transmission also are soft and vulnerable, often aluminum or special fabric. 

One sign a heat shield will give you that it's loose is noise; you'll sometimes hear it rattling underneath your vehicle when it's running. One way to locate it? Put your vehicle in park, leave the engine running and take a listen outside.  It's usually pretty easy to pinpoint the location.

Make a note of the noise when you are talking with your service advisor. It's important to have those heat shields working correctly so the heat is kept away from your other vehicle systems and combustibles on the ground. The good news is that heat shields can frequently be inexpensively repaired or re-attached.  In other cases, they should be replaced. 

Missing or loose heat shields? Let's just say they're not cool.

Car Doc On The Island
419 South Tamiami Trail
Venice, FL 34285
(941) 786-1595
http://www.cardocontheisland.com